"The Ball" - Fine
SHIPPING TO AUSTRALIA AND NEW ZEALAND ONLY.
ANY PURCHASE OUTSIDE OF AUSTRALIA  OR NEW ZEALAND WILL BE REFUNDED MINUS THE NON-REFUNDABLE PAYPAL FEE.

"The Ball" - Fine *NEW*

A variation of one of our best sellers -  the "Fine Ball" is the perfect shape for removing dead protein and cuticle in place of cuticle nippers.

• Diamond Bit
• 100% Tungsten Steel
• Cuticle Bit 
• Ball shape 
• Fine Grade 
• Suitable for Manicure & Pedicure 
• Step 2 piece 
• Perfect for removing dead protein & cuticle 
• For clients with less cuticle but in need of a smaller ball to get into those hard to reach areas (it is the same size as the Medium Ball) 
• Standard shaft width of 3/32" 
• Fits all E-file Machines 

The Willow Range is compiled of our best pieces to make your job more effective, cost efficient and easier on your body as well as your pocket. 

The bit must be cleaned periodically to remain sharp by following the manufacturer's instructions. Drill bits usually last 2-3 months but this can vary dependent on how busy you are. 

AFTERCARE & CLEANING: 

• Use warm soapy water, our Spit-Spot-Bit-Pot and our Willow Brass Brush to remove the dust and product debris from within the grits, flutes and teeth. 

• Do not allow the bit to air dry!

• Once the bit is fully clean and dry you can use your preferred sterilising method. 

• We recommend our "Willow Spray & Go" system as the less time your bits spend immersed in solution, the better!

• Lay your E-file bits on a towel and evenly spray the Spray & Go over all of the bits.

• Roll the bits over and spray evenly again.

• If soaking in barbicide please only steep for the recommended time, over-steeping can dull your drill bits.

• Wait 2 mins and then dry all of your bits thoroughly by hand (do not leave to  air dry)

• Store in your bit case or bit book

TIPS & TRICKS

For nail art ideas please check out our YouTube channel: Dixie Girlxox