"The Buffer Bit" - (Extra Fine)
SHIPPING TO AUSTRALIA AND NEW ZEALAND ONLY.
ANY PURCHASE OUTSIDE OF AUSTRALIA  OR NEW ZEALAND WILL BE REFUNDED MINUS THE NON-REFUNDABLE PAYPAL FEE.

The Buffer Bit 

We have been waiting for a bit like this for so long. This long barrel shaped bit with a cross hatched grit is the metal alternative to a hand buffer. It will buff product to a high shine making finishing & refining nails cost efficient.

The Buffer Bit lasts 6-12 months! 

The bits life can vary and is dependent on your cleaning routine & product used. 

Details: 

• Long barrel shaped 
• 2.3mm 
• Buffs product to a shine helping reduce refining time and cost 
• Can be used to buff the natural nail
• Perfect for removing the base coat after removing colour coat
• Lasts approximately 6 months 
• Fits all E-file machines 
• 3/32" standard shaft width 

AFTERCARE & CLEANING:

• Use warm soapy water, our Spit-Spot-Bit-Pot and our Willow Brass Brush to remove the dust and product debris from within the grits, flutes and teeth.
• Do not allow the bit to air dry!
• Once the bit is fully clean and dry you can use your preferred sterilising method.
• We recommend our "Willow Spray & Go" system as the less time your bits spend immersed in solution, the better!
• Lay your E-file bits on a towel and evenly spray the Spray & Go over all of the bits.
• Roll the bits over and spray evenly again.
• If soaking in Barbicide please only steep for the recommended time, over-steeping can dull your drill bits.
• Wait 2 mins and then dry all of your bits thoroughly by hand (do not leave to air dry)
• Store in your bit case or bit book.

TIPS & TRICKS

For nail art ideas please check out our YouTube channel: Dixie Girlxox